initial

libraries/ArduinoModbus/examples/RTU/ModbusRTUTemperatureSensor/ModbusRTUTemperatureSensor.ino

@@ -0,0 +1,65 @@
+/*
+  Modbus RTU Temperature Sensor
+
+  This sketch shows you how to interact with a Modbus RTU temperature and humidity sensor.
+  It reads the temperature and humidity values every 5 seconds and outputs them to the
+  serial monitor.
+
+  Circuit:
+   - MKR board
+   - Winners® Modbus RS485 Temperature and Humidity:
+     https://www.banggood.com/Modbus-RS485-Temperature-and-Humidity-Transmitter-Sensor-High-Precision-Monitoring-p-1159961.html?cur_warehouse=CN
+   - External 9-36 V power Supply
+   - MKR 485 shield
+     - ISO GND connected to GND of the Modbus RTU sensor and the Power supply V-
+     - Power supply V+ connected to V+ sensor
+     - Y connected to A/Y of the Modbus RTU sensor
+     - Z connected to B/Z of the Modbus RTU sensor
+     - Jumper positions
+       - FULL set to OFF
+       - Z \/\/ Y set to ON
+
+  created 8 August 2018
+  by Riccardo Rizzo
+*/
+
+#include <ArduinoModbus.h>
+
+float temperature;
+float humidity;
+
+void setup() {
+  Serial.begin(9600);
+  while (!Serial);
+
+  Serial.println("Modbus Temperature Humidity Sensor");
+  // start the Modbus RTU client
+  if (!ModbusRTUClient.begin(9600)) {
+    Serial.println("Failed to start Modbus RTU Client!");
+    while (1);
+  }
+}
+
+void loop() {
+
+  // send a Holding registers read request to (slave) id 1, for 2 registers
+  if (!ModbusRTUClient.requestFrom(1, HOLDING_REGISTERS, 0x00, 2)) {
+    Serial.print("failed to read registers! ");
+    Serial.println(ModbusRTUClient.lastError());
+  } else {
+    // If the request succeeds, the sensor sends the readings, that are
+    // stored in the holding registers. The read() method can be used to
+    // get the raw temperature and the humidity values.
+    short rawtemperature = ModbusRTUClient.read();
+    short rawhumidity = ModbusRTUClient.read();
+
+    // To get the temperature in Celsius and the humidity reading as
+    // a percentage, divide the raw value by 10.0.
+    temperature = rawtemperature / 10.0;
+    humidity = rawhumidity / 10.0;
+    Serial.println(temperature);
+    Serial.println(humidity);
+  }
+
+  delay(5000);
+}